Emo Christmas bauble

Emo Christmas bauble

I need to get some more colorful filament for my printer 😉

However I think I’ve got the settings pretty well dialed in- I printed this little (well, about 3 inches across) Christmas bauble today and it came out great!

It took about 9 hours, but it’s 5 curved sections that all printed one inside the other as in this picture, then when you break it off the printer bed they stay inside each other and you can move them around to make it look however you want it to (and yes, I’m using a little “elf village” I had previously printed on printer #1 as a stand to show it off)…

Leave a Reply

Your email address will not be published. Required fields are marked *